Open and close your parasol with ease

fully integrated into the parasol pole and not visible; start-up using Plug&Play; opening and closing after pressing the remote transmitter for 3 seconds (protective function to prevent accidental activation), range between radio transmitter and parasol pole approx. 82'; activated by remote control only; no wired operation (hardwiring) possible; incl. hand crank for emergency use in the event of a power failure. The motors can only be used in combination with the bases with locking hinges, e.g. AZ024, AZ120, SZ150 etc. Compatible with LED lighting, not compatible with radiant heaters or loudspeakers. Connection: 230 V~ / 50 Hz.

sufficient for use with one parasol. 1-channel (2 signals): For operation of one parasol or for simultaneously opening/closing a group of parasols.

suitable for the single radio transmitter 202105. Secure to a wall.

for use with several parasols. Allows individual and group activation of the parasols. Programmed ex-works, subject to agreement. 18-channel (36 signals): For operating 18 parasols or groups separately. Each motor can react to 3 radio transmitter signals, for example “Parasol #3”; “Group on west patio”; “All parasols as a group”. Each motor can also react to 2 wind sensors.

suitable for the 18-channel radio transmitter 202106. Secure to a wall.

The radio transmitter is secure to the wall as a fixed unit. Direct visual contact with the radio receiver is required. For operation of one parasol or for simultaneously opening/closing a group of parasols (2 signals).

2-channel radio transmitter station for opening and closing using tubular motors by means of a home automation system (e.g. elero, elsner, GIRA, KNX, LOXONE, Rademacher or somfy). Direct visual contact with the radio receiver is required. 2-channel (4 signals): For operating 2 parasols or 2 groups separately. Unidirectional and sequential activation. Easy integration using isolated switch contacts (> 3 sec). Can be combined with an 18-channel radio transmitter for individual and group activation. Input 12 V / 24 V DC or 230 V~ / 50 Hz.

The wind sensor measures the wind speed and automatically gives the tubular motor the signal to close the parasol; a potentiometer is used to set the sensitivity of the signal. Solar and remote operation; no cabling required. It is secured in a suitable spot using the two wall plugs included. It should be installed in the most exposed spot, and close to the parasols. Direct visual contact to the radio receiver is required. Only suitable as an aid; when the wind picks up, the operator remains responsible for closing the parasols and securing them with a cord.